CoolingRate相关论文
乙二胺(EDA)导向的磷酸钴和1,2-二氨基丙烷(PDA)导向的磷酸锌水热晶化产生了一个有趣的结果,晶化产物受反应釜降温冷却速率支配.为......
During the direct chill (DC) casting process, primary cooling from the mold and bottom block, and secondary cooling from......
Evolution mechanism of recrystallization in a nickel-based single crystal superalloy under various c
The recrystallization behaviors of a nickel-based single crystal superalloy during heat treatment at 1,200 ℃ for 4 h wi......
Effect on microstructure and plastic deformation behavior of a Zr-based amorphous alloy by cooling r
In this study,Zr41.2Ti13.8Cu12.5Ni10Be22.5 amorphous alloys samples with the same diameter(8 mm)were prepared by using s......
Influence of Deformation Degree and Cooling Rate on Microstructure and Phase Transformation Temperat
To study the effects of the deformation degree and cooling rate on the microstructure and phase transformation temperatu......
Effect of Cooling Rates in Coiling Process on Microstructures and Mechanical Properties in Al-Bearin
In this study,the effect of cooling rates on microstructures and mechanical properties in a Al-bearing hot-rolled transf......
The transformation mechanism of (γ + γ\') was studied by analyzing the microstructure and elemental distribution of ......
Effect of Cooling Rate on Microstructure and Mechanical Properties of Sand-Casted Al-5.0Mg-0.6Mn-0.2
This study examines the relationship among cooling rate,microstructure and mechanical properties of a sand-casted A1-5.0......
Influences of pouring temperature and cooling rate on microstructure and mechanical properties of ca
...
...
Effect of Fast Cooling Rate on the Microstructure and Mechanical Properties of Low-Carbon High-Stren
The effect of fast cooling rate on the microstructure and mechanical properties of low-carbon high-strength steel anneal......
Quenching experiments were performed at different cooling rates under non-directional solidification by differential the......
In the slagging gasifier,coal ash slag viscosity is the key factor for continuous slagging.In order to prevent operation......
Effects of cooling rates on the δ-Ferrite/γ-austenite transformation and martensite transformation i
Aimed at clarifying the δ-ferrite formation in fusion welding of ferritic/martensitic steels,effects of cooling rates o......
EFFECT OF AUSTENITE DEFORMATION AND CONTINUOUS COOLING ON MICROSTRUCTURE EVOLUTION IN A PIPELINE STE
The effect of austenite deformation and continuous cooling on the evolution of microstructure in a high temperature proc......
Antifreeze proteins(AFPs)and antifreeze glycoproteins(AFGPs),collectively abbreviated as AF(G)Ps,possess a unique abilit......
纳米颗粒由于自身的小体积效应，在低温生物学中有广泛的应用，但未见将纳米颗粒应用于卵母细胞玻璃化保存的报道。本文将不同粒径的羟......
Cooling rate calibration and mapping of ultra-short pulsed laser modifications in fused silica by Ra
This paper focuses on the preparation of a new extended set of calibrations of cooling rate (fictive temperature) in fus......
In this paper,an irreversible thermionic refrigerator model based on van der Waals heterostructure with various irrevers......
Effect of Cooling Rate on Microstructure Evolution of Hot Forming High Strength Steel Based on Non-I
Constitutive equations based on isothermal tensile test were applied when traditional researchers performed numerica......
Current studies of crystallization kinetics of glass fiber reinforced polypropylene limitedly focus on short glass f......
In this paper, the influence of cooling rate on the undercooling of droplet solidification of metal melt has been invest......
The crystallization behavior of blast-face slag under isothermal and continuous-cooling conditions was studied using the......
An innovative method for calibrating local cooling rate in electroslag remelting of M42 high-speed s
The determination of the local cooling rate has a great significance in optimizing the parameters of electroslag remelti......
The thermal conductivity or diffusivity of pearlitic grey irons with various carbon contents is investigated by the lase......
介绍了新研制的水溶性淬火剂ＰＭ１２１－２００Ｔ，测定了其物理性能及不同浓度和不同温度下的冷却性能，对不同浓度下的淬火工艺性能也进行了研究，结果表明......
